2003 Toyota Celica GTS TRD Panasonic Edition in Middle Sackville, NS

Seller note:

2003 celica gts trd panasonic edition. Taking offers as is, or as will be. Start off with the good, has new tires all around still with the nubbies, cross drilled rotors and pads, rtx 17' rims, tinted tail lights, haylo projector heads lights, HID 4300k kit, AEM intake, lowered 3', camber kit, just had 4 wheel alignment done, new tranny with [removed phone]k, new just broke in Exedy stage 2 clutch. Bottom of car was just painted, clean, clean enough to eat off. Only rust spots on car is the very front of both front fenders where the bumper bolts onto, started to wear a little and a little bit of rust is showing. Can be sanded and painted as good as new.

Now the bad, drove the car to NB and came home. Second day home the oil pump went in it, they are knowen for them to go, motor is out and stripped ready to rebuild. Head is fine, cam lobes are not scored, cams are not scored, cam caps are not scored, the valves on the intake side were all bent though but were not stuck in guides or broke, the valve guides are fine. Bottem end is fine, cylinders are not scratched and scored, cylinder bores are on spec of 82mm, pistions and rods are fine, should replace rings sence its apart, main and rod bearings were fine and not scored or wore, crank is fine. The motor can be rebuild with little parts, like a new set of rings, gasket kit and some valve seals and intake valves.

I will sell it without the motor, or with the motor rebuilt as a motor build. Price will obv be higher with motor built, and lower without the motor rebuilt. The motor will be build with.

PPE header
PPE mid pipe with high flow cat
New OEM crankshaft sprocket
New OEM timing chain
New OEM timing chain tenshioner
OEM 2zz motor gasket kit
Mehle 12.3:1 compression 82mm pistions
MWR main bearings
MWR rod bearings
MWR thrust bearings
Piper 2zz stage 3 cams
MWR circuitworx better flow oil pimp
MWR valve springs and Ti retainer Combo kit
MWR valve set
MWR valve seal kit
ARP head stud kit
ARP rod bolt kit
ARP main bolt kit
Koyo Racing better flow rad
Injen cold air intake
Skunk2 3 inch axle back exhaust
Tuned with Apexi power FC + commander tunable ECU

No trades, email with any questions, or if more pictures of car or motor is wanted.